GrimmSpeed Installation Guide Series Installing the Mitsubishi Evo 8/9 Master Cylinder Brace Updated 7/17/12 Introduction: This guide will illustrat
2. Next, remove your factory strut tower bar. This will be three (3) 14mm nuts on each side plus two (2) 14mm bolts in the center. Set it aside when
3. The brace mounts to the top of the strut tower and straddles an existing stud further down towards the ground. Locate that stud and remove the 1
5. Now, there should be plenty of room to slip the brace down so that the tab on the bottom straddles the stud and the three studs at the top of th
6. Now set your strut tower bar back in place. Before moving forward, you’ll want to reinstall the two 14mm bolts attaching it to the firewall. If
7. Reinstall the three (3) 14mm nuts on each strut tower, six total. 8. Now you’re ready to install the stud, nuts and red cap. See the figure bel
9. The next step is to pre-tension the brace assembly. Make sure you keep the nut closest to the battery loose. Sometimes, I’ll remove it all-toget
Comments to this Manuals